Special tricks segmental massage

August 12, 2017 17:50 | Massage

drilling reception. When drilling is used two or three rotational and helical motion, strictly towards the spine.The depth of the impact of intake should be increased gradually up to 5 kg.Admission (one drilling) performed in for 3-4 seconds, after which the pressure force of the implementation of rotational and helical movements gradually decreases and stops.If necessary, the reception can be performed with the advancement from one segment to another (from the periphery to the center) at the lowest pressure massaged area.Brush massage therapist should be supported, mainly on the fingers, is not directly involved in the implementation of the reception.

Varieties receiving drilling: 1) I and II-IV fingers, 2) I with your fingers;3) the middle phalanx;4) bar drilling.

performance technique. Drilling I and II - IV fingers used to eliminate reflex changes in muscles of the back and is combined with the intake strokes.The position of the masseur - massed in front of the back, usually to the left

of the massaged lying on his stomach.The right hand is placed on the area of ​​the sacrum, so that I was on the left thumb of the spinal column, and other fingers - on the right spine is between I and the other fingers (Figure 62 as well.).After that I do finger semicircular motion to the spine to the paravertebral line, where he carried out drilling of the distal phalanx, moving the cloth in the direction of the vertebral column.In BPE

mi performing this movement and drilling support are 2-5 fingers.Since the left region of the back massaged upwards from one segment to another (Fig. 62 b).

same way, but the distal phalanx II-V fingers massaging the right side of the spine from the bottom up, with I now only serves as a finger support.

to adjust the pressure of the left hand can be located on the right.

Drilling I fingers. reception is performed during a massage the buttocks, waist, back, long muscles of the upper and lower limbs for selective effects on a limited hypertonicity (voltage) muscles miogelezy (seals in the muscles) and in the most painful points.

Fig.62. Drilling I and II - IV fingers.

and - first phase starting position massaging hands;b - second phase: a semicircular sliding I finger to the spine and the drilling of the distal phalanx.

Fig.63. Drilling I finger with burdening the ulnar edge of the hand of the other hand.

In carrying out this sort of reception pads and distal phalanges of the fingers I have at an angle of 45-50 ° with respect to the massaged tissue, while the other fingers are supported.The rotational and helical movement in the back performing strongly in the direction of the vertebral column.This kind of reception I can perform a finger of one hand.Receiving technique is the same as when the two hands.

In order to enhance the effect of exposure to the reception is carried out with the weights.In this case the elbow brushes the edge of one hand is superimposed on the base of a finger of the other hand I, and the reception is carried out with a much larger force (4-5 kg), at a slow pace - for 4-5 sec (Fig. 63).

Drilling middle phalanges applied during a massage large muscle groups (gluteus, deltoid, thigh muscles), fascia lata and the lumbar region.The rear surface of the middle phalanges is superimposed on the symmetrical massaged area, and drilling is performed.Fingers lightly clenched in a fist, I fingers are supported.This technique is often performed middle phalanx II and III fingers.The impact - up to 4-5 kg, the rate - for a 4-5 (Figure 64.).

To increase the effect of exposure method is used with the weights, mainly in the area of ​​the gluteal muscles.In this case the palm of the free hand is superimposed on the rear surface of massaging.Receiving depth gradually increases exposure to 5 kg and above.drilling pace is slow - for 5-6 seconds.

Barcode drilling. Regulation masseur - massed in front of the back, usually to the left of the massaged.In this position, the entire palmar surface of the left hand of the masseur with the best lead I put the finger on the lower part of the chest so that the finger I was in a 3 to 4 cm from the spinal column strictly on the near paravertebral line.The rest of the fingers are the backbone for the finger and I need to be on the far back area (Fig. 65 as well).The right-hand brush masseur superimposed on the lateral surface of the back massaged.The distal phalanx of thumb I, from the mid-axillary line, performs a deep linear motion ( "bar") on the eleventh intercostal space in the direction of the spine during 5-6 (Fig. 65, b, c).In summing up I brush right toe to toe I left last 3-4 simultaneously perform drilling in a clockwise direction (Fig. 65, d, e).

Fig.64. Drilling the back surface of the middle phalanges of the buttocks.

Fig.65. Reception bar drilling.

well - the first phase starting position massaging hands;b - the second phase: the beginning of the rectilinear movement (bar) I finger;in - the second phase: the end of the stroke;g - third phase: the beginning of the drilling;d - the third phase drilling;. E - fourth phase starting position massaging hands while moving the finger of the left hand at 2-3 cm

pressure force at a stroke, and drilling is controlled by the appearance of a distinct skin flushing.Then I moved a finger of the left hand sliding motion to 2-3 cm to the overlying vertebra (Fig. 65, e), and I finger of the left hand performs the bar on the tenth intercostal space, and so on. Etc. .. to the bottom of the blade angle.

When you receive a different area of ​​the back masseur goes to the opposite side of the couch.If the therapist does not change its position, the distal region of the back is massaged in the same way, but the distal phalanx II and III fingers and toes are I support them (Fig. 66).

Reception "movement» used to eliminate reflex changes in muscles of the back and is always combined with the intake strokes.

Regulation masseur - massed in front of the back, usually to the left of the massaged.The right hand, fixing pelvis massaged, is located on the right buttock and wraps his fingers iliac crest.The left palm produces helical, circular movements to the vertebral column (clockwise), displacing all the tissue starting from the bottom left of the chest, and gradually moving to the left shoulder girdle.At the same time the right arm makes movement in the opposite direction (counterclockwise), all the while staying in one place.If done correctly, the reception is as if twisting of the spine to the muscles paravertebral areas (Fig. 67).Then, placing his hands on the opposite massaging the back, right hand palm massage therapist performs helical movement on the left buttock in a clockwise direction, and the palm of his left hand on the right section of the chest - anti-clockwise (Fig. 68).

Fig.66. Barcode drilling distal phalanx II and III fingers on the far back area massage therapist

Fig.67. Move (twisting) at the position on the side of the masseur massaged around the hips.

Fig.68. Move (twisting) at the position opposite the masseur massaged the back.

If the therapist changes its position after the first part of the reception and appropriately performs twisting the other hand massaged, then also there is a change of hands massaging.

After each "move" is performed stroking the entire palmar surface of the hands, and when stroking committed semicircular motion to the spine in an upward direction (Fig. 69).

saw Reception applied to the back, it acts primarily on the connective tissue.

Regulation masseur - massed in front of the back on either side.The radial edge brushes of both hands to the maximum allotted fingers I and II are placed on the back region in two ways: in the first embodiment, so that one side of the spinal column are fingers I and on the other - II (Figure 70 as well.);in the second embodiment, the radial edge of the brush overlap on the paravertebral muscles parallel the spinous processes of the vertebral column (Fig. 70, b).Brushes pronated, the distance between them - 3-4 cm, fingers fit snugly to the massaged area and a little closer, that between them there was a skin roller.Thereafter, produce sawing both hands in opposite directions of movement, massaging the whole surface of the back bottom up segment to segment, the fingers must be longer entrained depose skin than slide across it.

Receiving this can also be performed in the neck and extremities.

Reception "traction» (Sliding) affects reflex changes in the (developed E. Dicke 1958) subcutaneous connective tissue.

reception is performed mostly palmar surface of the distal phalanges II, III or IV in the form of finger touch.On the chest and back movements are made in the direction of the spine (Figure 71.);in the neck and shoulder girdle - cross;extremities - mostly along the lymph flow.

Fig.69. Stroking the back in segmental massage.

Fig.70. Acceptance of the saw.

and - first option: Brush massage therapist across the spine; b - second option: masseur brush along the spine.

Fig.71. Traction (Sliding).

well - the first short and intermittent bar in the back;b- a second bar.

massaging finger penetrating into the subcutaneous connective tissue layer and remaining in it glides slowly, drawing out the hard connective tissue.The pressure depends on the desired depth of influence.To perform the stroke movement can be short and intermittent or long and slow;Recently, more intense effect on the tissue (Fig. 72).

tense subcutaneous connective tissue has a strong resistance to massage the finger, finger, as it were stuck in this tissue.By repeating the reception there is a gradual outgoing voltage of the connective tissue.In addition, massaged pain may arise and appear dermograficheskaya reaction (redness) in a broad band.Much pain and a broad, long-lasting red stripe, and sometimes the formation of skin roller (protrusion) on the site of the stroke characteristic of the more pronounced subcutaneous connective tissue tension.

Reception "roll forming» used to identify and address local hypertension, muscle and connective tissue tension.

Fig.72. Traction (Sliding).

and - the beginning of a long, slow stroke in the thigh;b - end of the movement.

Fig.73. Wrapping in the back.

and - beginning of the movement;b - in the middle of the movement.

I masseur fingers, touching each other with their pads, perform stroking his side surface.At the same time the rest of the fingers, capturing the soft tissue, rolls of their fingers on I operating stroke (Fig. 73, b).

Local hypertension, muscle and connective tissue stress I felt the fingers of the masseur as additional resistance.

reception is performed by two or one arm and is often used for palpation massaged (see. Below).

Reception "concussion» applied in the pelvis and chest muscle tension to eliminate these areas.

Regulation massaged - prone, the therapist stands about knee on either side, the most convenient for him.Lightly brush cover pronated lumbar massaged so that the fingers touched

each other in the abdomen (Fig. 74 as well).II fingers with slight pressure deep into the tissue between the lower ribs and the iliac crest.Short and continuous lateral oscillating movements of the masseur hands simultaneously or alternately operate the shaking pelvis, and the hands slowly slide to the lumbar-sacral spine (Fig. 74, b).

When you receive the chest massage therapist grasps its side faces, palms, slightly compresses and provides jerky movements, sliding his hands over his chest to the spine.Massed at this time makes the elongated exhale through the mouth.Admission to the chest can be performed at a position massaged while lying on his back.Vibrational, jerky movements start from the sternum toward the spine massaged simultaneously with exhalation (Fig. 75).

Fig.74. Shaking the pelvis and thorax and - initial phase;b - the final phase.

Fig.75. Shaking in the chest at position massaged while lying on his back, and - the initial phase;b - final phase.